# GEN | General Operating Instructions ## **CHAPTER 1 Altimeter Setting Procedures** ### **1.1 Altimeter Setting Procedures** #### **1.1.1 Departing Aircraft** Departing aircraft should state the ATIS INFO letter on first contact with GND. It should be issued by the GND controller. Aircraft should be informed of any subsequent change to the QNH at the earliest opportunity. #### **1.1.2 Arriving / Transiting Aircraft** At or below the Transition Altitude, an aircraft’s vertical position will be controlled by reference to the Ben Gurion QNH. Aircraft will be issued the QNH once cleared to descend to an altitude by Tel Aviv or Ben Gurion APP. Aircraft should be informed of any subsequent change to the QNH at the earliest opportunity. #### **1.1.3 Transition Altitude/Level** The Transition Altitude (in the LLLL FIR) is 18,000 feet AMSL **ABOVE THE SEA.** **When flying above** **land,** the transition altitude is set to 35,000ft. **Note:** From here on, unless otherwise specified, vertical references are measured in ft are to be assumed as altitudes AMSL. ## **CHAPTER 2 All Weather Operations** ### **2.1 Low Visibility Procedures (LVP)** #### **2.1.1 Enforcement** Pilots will be informed when these procedures are in operation by ATIS or by R/T. ATC Low Visibility Procedures must be applied when the RVR is less than 800m (or visibility below 1200 meters). #### **2.1.2 Runway Visual Range (RVR)** The RVR is measured at three points along each runway: at the touchdown zone, mid-point, and stop-end. The minimum RVR that can be measured is 50 m, and the maximum is 1500 m. Only the touchdown zone RVR value is published in METARs; the remaining two RVR values are ‘unknown’ to VATSIM network controllers. When LVP is in force, pilots should be informed of the reported RVR and any subsequent updates. ## **CHAPTER 3 Description of Airfield** ### **3.1 Aerodrome Geographical Data**
LLBG **ICAO Code**
LON: 320034N LAT: 0345308E **Aerodrome Reference Point (ARP)**
400 M from THR 30
134 ft AMSL **Elevation**
18,000ft AMSL (SEA) // 35,000ft AMSL (LAN) **Transition Altitude**
2000ft (West), 5000ft (East) **Safety Altitude**
### **3.2 ATC Communication Facilities** #### **3.2.1 Aerodrome Control (ADC)**
Callsign Logon Callsign Abbreviation Frequency (MHz)
Ben-Gurion Departure Information LLBG\_D\_ATIS ATIS DEP 132.800
Ben-Gurion Arrival Information LLBG\_A\_ATIS ATIS ARR 132.500
Ben-Gurion Clearance LLBG\_DEL DEL 121.550
Ben-Gurion Ground LLBG\_E\_GND GND East 121.950
Ben-Gurion Ground LLBG\_W\_GND GND West 121.750
Ben-Gurion Tower Arrival LLBG\_A\_TWR TWR ARR 132.100
Ben-Gurion Tower Departure LLBG\_D\_TWR TWR DEP 134.600
**Note:** When AIR is split (and in the absence of an ADC Supervisor), AIR South shall operate as the ADC Supervisor and is responsible for overall aerodrome operations and executive coordination with external units. #### **3.2.1** **Approach Control (APC)**
Callsign Logon Callsign Abbreviation Frequency (MHz)
Ben-Gurion Approach LLBG\_D\_APP DEP 120.500
Ben-Gurion Approach LLBG\_A\_APP APP 131.100
Ben-Gurion TMA LLBG\_T\_APP TMA 119.500
### **3.3 Logon Order** #### **3.3.1 Aerodrome Control** TWR DEP is the primary tower and should be opened in the first instance. Before TWR is split, RWY 21 must be in use, and there must not be a single RWY OP active. GND West is the primary position, and after that, GND East may open, and only then BGN DEL. #### **3.3.2 Approach Control** DEP may be staffed at any time. ARR may open only when DEP is staffed, when RWY 21 is in use for ARR, and when there is no single RWY OP. TMA is last in priority to be staffed ### **3.4 Radio Navigation and Landing Aids**
Type Identifier Frequency (MHz)
ILS 21 BN 109.700
ILS 30 BD 111.900
ILS 12 BG 110.300
ILS 26 BA 108.700
ILS 08 BC 110.900
## **CHAPTER 4 Use of Runways** ### **4.1 Preferential Runway System** Runway 26 is the preferred runway for departure. Runway 21 is the preferred runway for arrival during the day, but due to Noise abatement procidures & winds, there is a rotation between RWY30, RWY21, and RWY12. At night, RWY12 is the preferred runway for ARR due to noise-abatement procedures Backwind at or above 5KTS shall initiate a change of active ARR runway. ### **4.2 Change of Runway Configuration** When there is a change of runway configuration, TWR DEP shall initiate contact with DEP to agree on a last arrival and time for the runway change. DEP shall confirm with all APC stations about the change of configuration. Based on this time, TWR DEP shall coordinate with GND\\DEL as to the last departure. GND\\DEL will re-clear any previously cleared aircraft that will now depart on the new runway. TWR DEP shall inform DEP of the intended last 3 (if appropriate) departures before, and the first departure after, the runway change (callsign and routing). DEP will inform TWR DEP when the runway change is completed. ### **4.3 Use of the Non-Duty Runway** Aircraft can land on the departure runway if technical or safety reasons preclude using the nominated arrival runway or to try and avoid a missed approach. Opposite-direction departures and approaches are not permitted except in an emergency.